Toro GrandStand Series - Ignition Switch Removal

ELECTRICAL
8-11Toro GrandStand Service Manual
8
Component Replacement
Ignition Switch Removal
1. Remove the wire harness and spade connector from
the back of the ignition switch (Fig. 1449).
3. Remove the switch through the front of the control
panel (Fig. 1451).
Fig. 1449 IMG-1220a
2. Depress the two tabs on the sides of the switch (Fig.
1450).
Fig. 1450 IMG-1227a
Fig. 1451 IMG-1230a