Toro GrandStand Series - Ignition Switch Installation

ELECTRICAL
8-12 Toro GrandStand Service Manual
8
Note: The switch must be orientated so it can be
read from the operator position (Fig. 1453).
Fig. 1453 IMG-1232a
2. Install the spade connector with the two pink wires to
the “I” terminal of the switch (Fig. 1454).
Fig. 1454 IMG-1234a
3. Install the wire harness to the switch (Fig. 1455).
Fig. 1455 IMG-1220a
Ignition Switch Installation
1. Install the switch into the control panel. Ensure that
the mounting clips have secured the switch in the
control panel (Fig. 1452).
Fig. 1452 IMG-1230a