Toro GrandStand Series - Power Take Off (PTO) Switch Installation; Electric PTO Clutch Removal

ELECTRICAL
8-14 Toro GrandStand Service Manual
8
Electric PTO Clutch RemovalPower Take Off (PTO) Switch Installation
1. Install the switch into the control panel. Ensure that
the mounting clips have secured the switch in the
control panel (Fig. 1459).
1. Turn the engine off and remove the key from the
ignition.
2. Set the parking brake.
3. Lower the mower deck to the lowest height-of-cut
position.
4. Remove the LH and RH belt covers (Fig. 1461).
Fig. 1459 IMG-1246a
2. Install the wire harness to the back of the switch
(Fig. 1460).
Fig. 1460 IMG-1240a
Fig. 1461 IMG-9548a
5. Loosen the front idler pulley by loosening the nut
(Fig. 1462).
Fig. 1462 IMG-9550a