Toro GrandStand Series - Page 449

ELECTRICAL
8-40 Toro GrandStand Service Manual
8
3. Secure the position of the switch by tightening the
two mounting screws (Fig. 1555).
Fig. 1555 IMG-1283a
4. Plug the wire harness into the switch (Fig. 1556).
Fig. 1556 IMG-1281a
2. With the brake engaged, position the switch so there
is an 1/8” (3mm) gap between the switch body and
the tab on the brake arm (Fig. 1554).
A. 1/8” (3mm) gap needed C. Switch
between switch and D. Switch button
brake lever E. Face of the switch
B. Brake lever
Fig. 1554 g. 64 G012873
A
A
B
B
D
E
C
C