Toro GrandStand Series - Page 66

CHASSIS
3-45Toro GrandStand Service Manual
3
8. Secure the spring cover with the cover clamp (Fig.
0167).
11. Lower the Height-of-Cut lever to the 3” (7.62cm)
Height-Of-Cut position (Fig. 0169).
Fig. 0167 IMG-9686a
9. Repeat steps 5 thru 8 on the other side if replacing
both gas spring assemblies.
10. Loosen the lower nut on the lift bar assembly ap-
proximately 3 turns until the Height-Of-Cut handle
can be taken out of the transport position (Fig.
0168).
Fig. 0168 IMG-9749a
Fig. 0169 IMG-9739a
12. Position the center blade in the front-to-back posi-
tion. Check the blade height at the front of the center
blade. Adjust the lower nut on the lift bar assembly
until the blade height measurement reaches 3”
(7.62cm) (Fig. 0170).
Fig. 0170 IMG-9746a