Toro GrandStand Series - Wheel Motor Housing Assembly Replacement

CHASSIS
3-49Toro GrandStand Service Manual
3
Wheel Motor Housing Assembly
Replacement
Wheel Motor Housing Assembly Removal
1. Apply the parking brake.
2. Break the torque of the four lug nuts securing the tire
assembly to the wheel hub (Fig. 0181).
Note: Only slightly loosen the lug nuts, do not
remove at this time.
3. Break the torque of the wheel motor shaft nut (Fig.
0182).
Note: Only slightly loosen the wheel motor shaft
nut, do not remove at this time.
Fig. 0181 DSCN-0608a
Fig. 0182 DSCN-0608a
4. Repeat steps 2 and 3 on the other side of the
machine.
5. Raise the rear of the machine and secure with jack
stands (Fig. 0183).
Note: Position the jack stands under the rear of the
deck.
Fig. 0183 DSCN-0606a