CHASSIS
3-62 Toro GrandStand Service Manual
3
21. Remove the two 45 degree grease ttings from the
LH and RH grease blocks (Fig. 0230).
Fig. 0230 DSCN-0744a
Cross Shaft & Lift Assembly Installation
1. Install the 45 degree grease tting into the LH and
RH grease blocks. Position the tting so it faces
upward (Fig. 0231).
Fig. 0231 DSCN-0747a
2. Position the HOC pin in the rear cross shaft
assembly (Fig. 0232).
Fig. 0232 DSCN-0740a
To Next Page
Loading...
