Toro GrandStand Series - Page 82

CHASSIS
3-61Toro GrandStand Service Manual
3
18. Remove the rear cross shaft from the machine (Fig.
0227).
Fig. 0227 DSCN-0730a
19. Remove the “E” clip securing the height of cut (HOC)
pin to the rear cross shaft assembly (Fig. 0228).
Fig. 0228 DSCN-0751a
20. Remove the HOC pin from the rear cross shaft
assembly (Fig. 0229).
Fig. 0229 DSCN-0740a
17. Remove the lift plates (Fig. 0226).
Fig. 0226 DSCN-0723a