CHASSIS
3-60 Toro GrandStand Service Manual
3
13. 2009 only: Remove the bolts, spacers, washers
and nuts securing the cross shaft assembly to the
carrier frame (Fig. 0222).
14. 2010 only: Using a blunt punch, drive the spiral
pins that secure the LH and RH pivot shafts to the
rear cross shaft assembly (Fig. 0223).
Fig. 0223 DSCN-0712a
Fig. 0222 DSCN-1602a
15. 2010 only: Remove the LH and RH pivot shafts
from the rear cross shaft assembly and carrier frame
hub (Fig. 0224).
Note: 48” and 52” decks are set to a narrow stance.
Remove the wheels to remove the pivot
shafts.
Fig. 0224 DSCN-0717a
16. Remove the four sets of carriage bolts and nuts (four
per side) securing the LH and RH lift plates to the
engine base (Fig. 0225).
Fig. 0225 DSCN-0720a
To Next Page
Loading...
