CHASSIS
3-59Toro GrandStand Service Manual
3
9. 2010 only: Remove the bolts and washers securing
the extension spring assemblies and chains to the
RH and LH sides of the control tower (Fig. 0218).
11. 48” and 52” decks only: Remove the nuts from
the end of the lift rods and remove the RH and LH lift
rods (Fig. 0220).
Note: Leave the inside nuts in their location to
minimize deck leveling adjustments at the end
of this procedure.
Fig. 0218 DSCN-0700a
10. Remove the “E” clips and washers securing the RH
and LH lift rod to the rear cross shaft assembly (Fig.
0219).
Fig. 0219 DSCN-0704a
Fig. 0220 DSCN-0707a
12. 60” decks only: Loosen the rear jam nuts securing
the LH and RH lift rods to the turn buckle, then re-
move the RH and LH lift rods (Fig. 0221).
Note: Note the position of the jam nuts to mini mize
deck leveling adjustments at the end of this
procedure.
Fig. 0221 DSCN-0710a
To Next Page
Loading...
