CHASSIS
3-58 Toro GrandStand Service Manual
3
4. 2010 only: Remove the dampener assembly that
secures the lift bar to the rear cross shaft assembly
(Fig. 0214).
7. Mark the hydraulic ttings and hoses so they can be
correctly installed upon reassembly (Fig. 0216).
Fig. 0214 DSCN-0793a
5. Remove the fuel tank. See “Fuel Tank Assembly
Removal” on page 3-26.
6. Remove the cable ties securing the high pressure
hoses (Fig. 0215).
Fig. 0215 DSCN-0689a
Fig. 0216 DSCN-0691a
8. Remove the high pressure hoses from the pump
ttings (Fig. 0217).
Note: Cap the pump and hose ttings to prevent
debris from entering the hydraulic system.
Fig. 0217 DSCN-0696a
To Next Page
Loading...
