CHASSIS
3-57Toro GrandStand Service Manual
3
Cross Shaft & Lift Assembly
Replacement
Cross Shaft & Lift Assembly Removal
18. Tighten the wheel motor nut and lug nuts (Fig. 0211).
1. 2009 only: Remove the lift assist cylinder. See “Lift
Assist Cylinder Removal (2009 only)” on page 3-40.
2. Place two boards under the deck and lower the deck
onto them (Fig. 0212).
Note: The boards need to be long enough to sup-
port the front and rear of the deck.
Fig. 0211 DSCN-0683a
A. 200 ± 25 ft-lbs. (271 ± 33 Nm)
B. 80 ± 10 ft-lbs. (108 ± 13 Nm)
Fig. 0212 DSCN-0685a
3. 2009 only: Remove the nut securing the lift bar to
the rear cross shaft assembly (Fig. 0213).
Fig. 0213 DSCN-0795a
19. Bleed the hydraulic system. See “Bleeding the
Hydraulic System” on page 6-95.
A
B
B
B
B
To Next Page
Loading...
