Toro GrandStand Series - Page 85

CHASSIS
3-64 Toro GrandStand Service Manual
3
6. 2009 only: Loosely install four carriage bolts,
Belleville washers, nuts (Fig. 0237).
Fig. 0237 DSCN-0784a
7. 2009 only: Tighten the four sets of fasteners.
8. 2010 only: The right side lift plate is secured with
three long carriage bolts and one short (Fig. 0238).
Fig. 0238 DSCN-0768a
9. 2010 only: Loosely install the short carriage bolt
and nut in the upper left bolt hole (Fig. 0239).
Fig. 0239 DSCN-0770a
5. Position the right hand lift plate over the grease
block with the bolt hole pattern aligned with the
mating pattern on the engine base (Fig. 0236).
Fig. 0236 DSCN-0758a