Toro GrandStand Series - Page 86

CHASSIS
3-65Toro GrandStand Service Manual
3
10. 2010 only: Loosely install the remaining three
carriage bolts, Belleville washers, and nuts (Fig.
0240).
Fig. 0240 DSCN-0772a
13. Loosely install four carriage bolts, Belleville washers,
nuts (Fig. 0242).
Fig. 0242 DSCN-0784a
11. 2010 only: Tighten the four sets of fasteners.
12. Position the left hand lift plate over the grease block
with the bolt hole pattern aligned with the mating
pattern on the engine base (Fig. 0241).
Fig. 0241 DSCN-0780a
14. Tighten the four sets of fasteners.
15. 2009 only: Install the spacer into the rear cross
shaft hub (Fig. 0243).
Fig. 0243 DSCN-1603a