CHASSIS
3-66 Toro GrandStand Service Manual
3
18. 2009 only: Repeat steps 15, 16 and 17 on the other
side of the unit.
19. 2010 only: Position the RH pivot shaft through the
carrier frame hub and rear cross shaft assembly
(Fig. 0246).
Fig. 0246 DSCN-0717a
17. 2009 only: Secure the assembly using a washer
and nut (Fig. 0245).
Fig. 0245 DSCN-1607a
16. 2009 only: Install the bolt through the carrier frame,
then through the spacer and hub assembly (Fig.
0244).
Fig. 0244 DSCN-1606a
To Next Page
Loading...
