CHASSIS
3-67Toro GrandStand Service Manual
3
20. 2010 only: Rotate the pivot shaft so the spiral pin
hole of the pivot shaft aligns with the spiral pin hole
of the rear cross shaft assembly, then secure the
assembly with the spiral pin (Fig. 0247).
Fig. 0247 DSCN-0791a
21. 2010 only: Repeat steps 19 and 20 on the LH side
of the machine.
22. 48” and 52” decks: Install the lift rod through the
lift rod bracket and secure with nut (Fig. 0249).
Fig. 0249 DSCN-0798a
Note: The spiral pin ends need to be ush to the lift
arm hub (Fig. 0248).
Fig. 0248 DSCN-1400a
23. 60” decks: Install the lift rod to the turnbuckle and
secure with jam nut (Fig. 0250).
Fig. 0250 DSCN-0797a
To Next Page
Loading...
