Toro GrandStand Series - Page 89

CHASSIS
3-68 Toro GrandStand Service Manual
3
25. Position the large washer over the rear cross shaft
stud (Fig. 0253).
Fig. 0253 DSCN-0807a
26. Secure the assembly using the “E” clip (Fig. 0254).
Fig. 0254 DSCN-0808a
24. Position the opposite end of the lift rod over the stud
on the rear cross shaft assembly (Fig. 0251).
Fig. 0251 DSCN-0801a
Note: Ensure the ange bearing is still in place (Fig.
0252).
Fig. 0252 DSCN-0804a