CHASSIS
3-69Toro GrandStand Service Manual
3
27. Repeat steps 24 through 26 on the other side of the
machine.
28. Replace the tting o-rings. Install the high pressure
hoses to the pumps in their original positions (Fig.
0255).
Fig. 0255 DSCN-0810a
29. Secure the hose routings using three cable ties (Fig.
0256).
Fig. 0256 DSCN-0689a
30. 2009 only: Install the lift assist cylinder. See “Lift
Assist Cylinder Installation (2009 only)” on page
3-43.
31. 2010 only: Position the chain between the pivot
shaft and extension spring assembly (Fig. 0257).
Fig. 0257 DSCN-0815a
32. 2010 only: Secure the extension spring assembly
and chain to the control tower using the bolt and
washer (Fig. 0258).
Fig. 0258 DSCN-0818a
To Next Page
Loading...
