CHASSIS
3-71Toro GrandStand Service Manual
3
Engine Base Replacement
Engine Base Removal
1. 2009 only: Remove the lift assist cylinder. See “Lift
Assist Cylinder Removal (2009 only)” on page 3-40.
2. Place two boards under the deck and lower the deck
onto them (Fig. 0263).
Note: The boards need to be long enough to sup-
port the front and rear of the deck.
Fig. 0263 DSCN-0685a
3. 2009 only: Remove the nut securing the lift bar to
the rear cross shaft assembly (Fig. 0264).
Fig. 0264 DSCN-0795a
4. 2010 only: Remove the dampener assembly that
secures the lift bar to the rear cross shaft assembly
(Fig. 0265).
Fig. 0265 DSCN-0793a
5. Remove the fuel tank. See “Fuel Tank Assembly
Removal” on page 3-26.
6. Remove the cable ties securing the high-pressure
hoses (Fig. 0266).
Fig. 0266 DSCN-0689a
To Next Page
Loading...
