CHASSIS
3-72 Toro GrandStand Service Manual
3
7. Mark the hydraulic ttings and hoses so they can be
correctly installed upon reassembly (Fig. 0267).
Fig. 0267 DSCN-0691a
8. Remove the high-pressure hoses from the pump
ttings (Fig. 0268).
Note: Cap the pump and hose ttings to prevent
debris from entering the hydraulic system.
Fig. 0268 DSCN-0696a
9. 2010 only: Remove the bolts and washers securing
the exten sion spring assemblies and chains to the
RH and LH sides of the control tower (Fig. 0269).
10. Remove the “E” clips and washers securing the RH
and LH lift rod to the rear cross shaft assembly (Fig.
0270).
Fig. 0269 DSCN-0700a
Fig. 0270 DSCN-0704a
To Next Page
Loading...
