CHASSIS
3-73Toro GrandStand Service Manual
3
11. 48” and 52” decks only: Remove the nuts from
the end of the lift rods and remove the RH and LH lift
rods (Fig. 0271).
Note: Leave the inside nuts in their location to
minimize deck leveling adjustments at the end
of this procedure.
Fig. 0271 DSCN-0707a
12. 60” decks only: Loosen the rear jam nuts securing
the LH and RH lift rods to the turn buckle, then
remove the RH and LH lift rods (Fig. 0272).
Note: Note the position of the jam nuts to mini mize
deck leveling adjustments at the end of this
procedure.
Fig. 0272 DSCN-0710a
13. 2009 only: Remove the bolts, spacers, washers
and nuts securing the cross shaft assembly to the
carrier frame (Fig. 0273).
14. 2010 only: Using a blunt punch, drive the spiral
pins that secure the LH and RH pivot shafts to the
rear cross shaft assembly (Fig. 0274).
Fig. 0274 DSCN-0712a
Fig. 0273 DSCN-1602a
To Next Page
Loading...
