Toro GrandStand Series - Page 95

CHASSIS
3-74 Toro GrandStand Service Manual
3
Note: 48” and 52: models use two guard mounting
brackets instead of the single guard panel
(Fig. 0277).
16. Remove the four carriage bolts and nuts securing
the mufer guard and guard panel to the carrier
frame, then remove both (Fig. 0276).
15. 2010 only: Remove the LH and RH pivot shafts
from the rear cross shaft assembly and carrier frame
hub (Fig. 0275).
Note: 48” and 52” decks are set to a narrow stance.
Remove the wheels to remove the pivot
shafts. Reinstall the wheels after removing
the pivot shafts.
Fig. 0275 DSCN-0717a
Fig. 0276 DSCN-0932a
Fig. 0277 IMG-0586a