5
SAFETY INSTRUCTIONS
22. Keep body and hands away from pin hole leaks or
nozzles that eject hydraulic fluid under high pressure.
Use paper or cardboard, not hands, to search for
leaks. Hydraulic fluid escaping under pressure can
have sufficient force to penetrate skin and do serious
damage. If fluid is ejected into the skin it must be
surgically removed within a few hours by a doctor
familiar with this form of injury or gangrene may result.
23. Do not overspeed the engine by changing
governor settings. To be sure of safety and accuracy,
have an Authorized TORO Distributor check maximum
engine speed with a tachometer.
24. Engine must be shut off before checking oil or
adding oil to the crankcase.
25. Allow engine to cool before storing machine in any
enclosure such as a garage or storage shed. Make
sure the fuel tank is empty if machine is to be stored in
excess of 30 days. Do not store machine near any open
flame or where gasoline fumes may be ignited by a
spark. Always store gasoline in a safety approved, red
metal container.
26. Perform only those maintenance instructions
described in this manual. If major repairs are ever
needed or assistance is desired, contact an Authorized
Toro Distributor. To ensure optimum performance and
safety, always purchase genuine TORO replacement
parts and accessories to keep the Toro all TORO.
NEVER USE WILL-FIT" REPLACEMENT PARTS AND
ACCESSORIES MADE BY OTHER
MANUFACTURERS. Look for the TORO logo to assure
genuineness. Using unapproved replacement parts
and accessories could void the warranty of The Toro
Company.
SOUND PRESSURE LEVEL
This unit has an equivalent continuous Aweighted
sound pressure at the operator ear of: 92 dB(A), based
on measurements of identical machines per Directive
84/538/EEC and amendments.
SOUND POWER LEVEL
This unit has a sound power level of: 104 dB(A)/1 pW,
based on measurements of identical machines per
Directive 84/538/EEC and amendments.
VIBRATION LEVEL
HandArm
This unit does not exceed a vibration level of 8.5 m/s
at the hands based on measurements of identical
machines per ISO 5349 procedures.
To Next Page
Loading...
