Maintenance
39
Adjusting
Grass\Mud Scraper
1. Loosen the locknut holding scraper to the engine
frame (Fig. 47).
2. Rotate scraper until they align with center of
pulley grooves (Fig. 47).
3. Tighten the locknut (Fig. 47).
Note: The scraper must not contact the pulley
on the sides or bottom of grooves.
Re-adjust if necessary
.
2
3
1
m–3776
Figure 47
1. Scraper
2. Locknut
3. Pulley
Adjust
PT
O Bellcrank
4. Engage PTO lever and check the clearance
between the bellcrank and the axle shaft (Fig.
48). Space should be 1/4” (6mm).
5. If adjustment is required, remove hairpin cotter
and clevis pin from bellcrank. Rotate clevis
clockwise on rod to increase or counterclockwise
to decrease clearance (Fig. 48).
m–3860
1
2
3
4
Figure 48
1. 1/4”
(6mm)
2.
Hairpin cotter
3.
Clevis pin
4. Clevis
To Next Page
Loading...
