Toro Recycler 20333C - Checking the Engine Oil Level; Adjusting the Cutting Height

CheckingtheEngineOilLevel
ServiceInterval:Beforeeachuseordaily
Note:Max.ll:20oz.(0.59l),type:SAE30detergent
oilwithanAPIserviceclassicationofSF,SG,SH,SJ,SL,
orhigher.
1.Movethemachinetoalevelsurface.
2.Removethedipstick(
Figure10).
Figure10
1.Dipstick
3.Wipethedipstickcleanwithacleancloth.
4.Insertthedipstickfullyintotheoil-lltube,then
removethedipstick.
5.Readtheoillevelonthedipstick(Figure10).
•IftheoillevelisbelowtheAddmarkonthe
dipstick,slowlypourasmallamountofoilinto
theoil-lltube,wait3minutes,andrepeatsteps3
through5untiltheoillevelisattheFullmarkon
thedipstick(Figure10).
•IftheoillevelisabovetheFullmarkonthe
dipstick,draintheexcessoiluntiltheoillevel
onthedipstickisattheFullmark.Referto
ChangingtheEngineOil(page15).
Important:Iftheoillevelinthecrankcaseistoo
lowortoohighandyouruntheengine,youmay
damagetheengine.
6.Installthedipsticksecurely.
AdjustingtheCuttingHeight
WARNING
Adjustingthecuttingheightmaybringyouinto
contactwiththemovingblade,causingserious
injury.
•Stoptheengineandwaitforallmovingparts
tostop.
•Donotputyourngersunderthehousingwhen
adjustingthecuttingheight.
CAUTION
Iftheenginehasbeenrunning,themuferwillbe
hotandcanseverelyburnyou.Keepawayfromthe
hotmufer.
Adjustthecuttingheightasdesired.Setthefrontwheelsto
thesameheightastherearwheels(Figure11).
Note:Toraisethemachine,movethefrontcutting-height
leversrearwardandtherearcutting-heightleversforward.
Tolowerthemachine,movethefrontcutting-heightlevers
forwardandtherearcutting-heightleversrearward.
Figure11
1.Raisethemachine2.Lowerthemachine
Note:Thecutting-heightsettingsare1inch(25mm);1-3/8
inches(35mm);1-3/4inches(44mm);2-1/8inches(54mm);
2-1/2inches(64mm);2-7/8inches(73mm);3-1/4inches
(83mm);3-5/8inches(92mm);and4inches(102mm).
8