Toro Super Recycler 20384 - Setup Procedures; Assembling and Unfolding the Handle

Setup
Important:Removeanddiscardtheprotectiveplastic
sheetthatcoverstheengineandanyotherplasticor
wrappingonthemachine.
Important:Topreventaccidentalstarting,donotinsert
theelectric-startbuttonintotheelectricstarterswitch
untilyouarereadytostarttheengine.
1
AssemblingandUnfoldingthe
Handle
NoPartsRequired
Procedure
WARNING
Assemblingandunfoldingthehandleimproperly
candamagethecables,causinganunsafeoperating
condition.
•Donotdamagethecableswhenassemblingand
unfoldingthehandle.
•Ensurethatthecablesareroutedtotheoutside
ofthehandle.
•Ifacableisdamaged,contactanAuthorized
ServiceDealer.
1.Raisetherearofthemachinehousingtoits
highestcutting-heightsettingbymovingthe2rear
cutting-heightleversallthewayforward.Referto
AdjustingtheCuttingHeight(page11).
2.Attachthehandleendstothemachinehousingwith
2washersand2handlebolts(Figure3),butdonot
tightenthehandlebolts.
G017457
Figure3
1.Washer3.Handleend
2.Handlebolt
Important:Routethecablestothe outside ofthe
handle(Figure3).
3.Rotatethehandlerearward(Figure4).
G017458
Figure4
4.Lockthehandleatyourdesiredheight.Referto
AdjustingtheHandleHeight(page10).
5.Torquethehandleboltsto14to17N∙m(120to160
in-lb).
6