Toro Z287L Z–Master - Maintenance Schedule; Recommended Maintenance Schedule

29
Maintenance
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first use
• Hydraulic fluid—check level
• Engine Oil—change
• Hydraulic filter—change
Each Use
• Engine Oil—check level
• Safety System—check
• Mower Housing—clean
• Engine Coolant—check
• Engine Cooling System—clean
1
Every 5 Hours
• Cutting Blades—check
• Blade Spindle Bearings—grease
Every 25 Hours
• Hydraulic fluid—check level
• Chassis—grease
1
• Linkage bushings—oil
1
• Battery—check electrolyte
Every 50 Hours
• Air Cleaner—service
1
• Belts—check for wear/cracks
• Tires—check pressure
• Service the spark arrester
Every 100 Hours
• Paper Air Cleaner—replace
1
• Spark Plug(s)—change
• Hydraulic lines—check
• Engine Oil—change
1
• Fuel System—check
• Cooling System Hoses—check
Every 200 Hours
• Oil Filter–change (200 hours or every other oil change)
1
• Fuel Filter—replace
• Engine Cooling System—check
• Hydraulic Filter—replace
Every 400 Hours • Engine Coolant—change
Every 500 Hours or at
Storage
• Castor Pivot — adjustment
• Wheel Hub Slotted Nut — adjustment
Before Storage Service
• Battery—charge, Disconnect cables
• Gasoline—drain
• Chipped Surfaces—paint
• Perform all maintenance procedures listed above before storage
1
More often in dusty, dirty conditions