TORP TC500 - The List of Warnings and Errors

THE LIST OF WARNINGS AND ERRORS
WWW.TORPMOTORS.COM
10
-KICKSTAND: Your kickstand is lowered.
Lift it to start riding.
-CRASH SENSOR: Crash sensor activates
in case of a fall. Turn the bike off and
turn it back on after a few seconds to
continue riding.
LIMIT:
-TEMP CONTROLLER: The temperature of
the controller has reached the top limit
value. The power will be gradually
reduced.
-TEMP MOTOR: The temperature of the
motor is rising. To prevent overheating,
the power will be gradually reduced. The
motor temperature limit is set in the
“Motor Temp Cuttoff” settings on the
"Settings" screen.
-MOTOR TEMP SENSOR: Motor
temperature sensor is not connected.
Power is limited.
-LOW VOLTAGE: The battery is almost
drained or there is a voltage sag due to
the acceleration. The power will be
gradually reduced.
-LOW REGEN: The battery is nearly full.
The regen will be reduced.
-BATTERY TEMP: Battery temperature
has reached limit values so the power
will be reduced.
-BMS TEMP: Discharge mosfets in BMS
have overheated. Power will be gradually
reduced.
CUTOFF:
-CUTOFF LOW VOLTAGE: The battery is
completely drained and the bike will not
start. You can set the cutoff value in
Voltage Min setting in the App (3rd
Screen) . Charge the battery to continue
riding.
-OVERVOLTAGE: Battery voltage is
above 90V.
-UNDERVOLTAGE: Battery voltage
dropped under the values set in the
controller`s settings. Charge the
battery.
-OVERCURRENT: Motor Current is
above permitted limit.
-CONTROLLER OVERTEMP: Controller
has overheated. Wait for it to cool
down to continue riding.
-MOTOR OVERTEMP: Motor has
overheated. Wait for it to cool down to
continue riding.
-PHASE FET: MOSFET error:
Controller`s phase is in short-circuit.
Contact the manufacturer.
-HALL SENSOR: Motor Hall Sensor
connector is not connected, or there is
a problem with the Hall Sensor itself.
Check the wiring.
-THROTTLE PROBLEM: The problem
with a throttle wiring was detected,
that has been solved in the meantime.
Turn your bike off and on again to
continue riding.
-THROTTLE #1: Throttle ADC rises too
fast. Throttle plus(+) short on gnd(-).
-THROTTLE #2: Throttle not
connected. Probably throttle plus(+)
wire is broken.
-THROTTLE #3: Throttle plus(+) and
gnd(-) shorted.
-THROTTLE #4: Throttle gnd(-) not
connected or broken.
-THROTTLE #5: Throttle plus(+)
shorted on signal.
Connect to the controller with the Torp App to see the Warning and Error
messages on the 1st screen in the app.