WWW.TORPMOTORS.COM
11
-CUTOFF THROTTLE: The throttle has
been activated while the bike is being
turned on.
-1st solution: Release the throttle
when turning on the bike;
-2nd solution: Re-calibrate the throttle
(see the "Setting up the Throttle"
section of this document) ;
-3rd solution: Check the wiring.
-CUTOFF BATTERY TEMP: The battery
has overheated. The bike will stop until
it cools down.
-HALL PROBLEM: The Hall sensor
disconnected during the ride. Check
the wiring.
-HALL DISCONNECTED: The Hall
sensor disconnected during the ride.
Check the wiring.
-CUTOFF BMS TEMP: The BMS mosfet
temperature has reached the limit. The
bike will stop until it cools down.
-WATER IN CONNECTOR (works with
HW version 1.4 and higher): Water
entered the main connector. Turn off
the bike immediately, disconnect the
main connector, and dry it out.
To Next Page
Loading...