WWW.TORPMOTORS.COM
3
INSTALLATION.
Before starting with the installation, drain the bike`s capacitors.
Switch off the fuse
Switch on the bike and wait for the capacitors to drain.
1.
2.
1. 2.
Now you can start removing the stock SurRon controller and the battery from the frame, and lower
the skid-plate that covers the wiring.
FOR THE INSTALLATION
you will need:
-2 M5 screws (smaller screws)
-A smaller hex key
STEP 1:
Place the controller in a way that the holes on its back align
with the upper holes on the bottom front of the frame.
STEP 2:
Insert each screw in one hole and fasten them by using a
smaller hex key.
1.
2.
To Next Page
Loading...