DON`T MESS THIS ONE UP!
STEP 5:
Connect the power and phase motor wires as shown on
the picture using the screws with washers that you have
removed from the controller in the previous step:
Power Wires:
-The red battery wire to the positive (+) electrode
-The black battery wire to the negative (-) electrode
Phase Motor Wires:
-The Blue motor wire to the letter B
-The Green motor wire to the letter G
-The Yellow motor wire to the letter Y
WWW.TORPMOTORS.COM
4
STEP 3:
There is a cable on the left of the controller.
Stick it behind the controller.
STEP 4:
There are 5 screws with washers already on the
controller. Remove them from the controller and
start connecting the controller to the phase
motor wires.
STEP 6:
Use a larger hex key to gently fasten the
screws with washers. Max Torque that should
be used is 3.5 Nm!
3.
5.
6.
STEP 7:
Put the bike`s skid-plate back to its original
position by screwing back the top screws on
each side.
7.
To Next Page
Loading...