Caution:
Stop Bike if you want to make some
operations on display , If you do not focus
exclusively on your riding environment, you
risk being involved in an accident.
Power on & off
--Long press
button with 3 seconds ; user
have to input password after power on if system
was activated with password protecting function.
light on & off
--Long press
button with 3 seconds ,there has
3 options for light on or off , Manual ,Auto-Manual,
Auto, LIGHT SENSOR will detect
the environmental light intensity and turn the light
on or off automatically if select Auto-Manual, Auto
options.
Switching Assistance level
--Short press
botton to increase assistance
level or button to decrease assistance level .
the maxim assistance level can be set from 1 to 8 .
usually more bigger level means more powerful
and more speed;
--Zero Level ,The electric assistance switched off
-- Special level A,C,R Level should be activated
by menu options.
-Auto Level ,System will automatically adjust the
power and motor speed according to the bike
speed .
--C Level -Strong power at C level when use pedal
sensor up-hill.
--R Level ,Motor will run backwards.
Walk assistance
--Walk assistance can make it easier for you to push
the bike. The assisting speed can reach a maximum
of 6km/h , Using the walk assistance function is
only recom-mended when pushing the bike and
make sure bike’s rim was touched with ground.
Cruise
--Long press
button to activate Cruise function
when bike speed is more than activated speed and
electric assisting is on ,
--Pull brake or move the pedal or pull the throttle or
press any key on display will cancel cruise
Caution: There is risk of accident if you didn’t
concentrate on riding.
Switching riding mode
--Three riding mode is ,ECO ,CITY ,SPORT, you can
select desired mode ，Press Info button(T24)
--ECO : Effective assistance at maximum efficiency
for maximum cruising range
--CITY : Uniform assistance with long cruising range
--SPORT: Powerful assistance for sporty off-road
riding, as well as for urban traffic
Clear Trip
--Both long press
button and button with 3
seconds , Trip meter will be cleared to zero.
To Next Page