To control a cabJe TV
converter:
Program the remote
control to recognize the
brand of your converter
(see "Programming the
remote control for use
with a VCR, DVD player,
or cable TV converter"
below). The buttons
shown at right will control
the cable TV converter.
Press the CABLE button
first.
Nurnbers
Channel +/--
CH
Programming the remote control for use with
a VCR, DVD player, or came TV converter
This remote control is pro-programmed to operate Toshiba VCRs and
DVD players. To control VCRs, DVD players, or cable converters other
than Toshiba models, you must follow the steps below to program your
remote control.
1. While holding down the CODE button, press the button for the
device you want to control (VCR, DVD, or CABLE).
2. Enter the 2_digit code listed on page 13 using the Number buttons
(0-9) within 10 seconds.
3. Point the remote control at the VCR, DVD player, or converter and
press POWER to test the code.
If the VCR, DVD player, or converter turns on, you have entered
the right code.
If the VCR, DVD player, or converter does not respond to the
remote control, you may have entered the wrong code. Repeat
steps 1~2 with another code.
For future reference, write down the codes you used:
VCR code
DVD player code
Cable TV converter code
12
Notes:
i /
0o ....
5
_EW _LAY
-- VCR
-- CABLE
- DVD
- Code
HZhen shipped from the factory, the remote
control is set to operate your TV.
If you do not enter the code within 10
seconds from step I or ff you enter a code
not listed below, this operation is canceled.
Each time you replace the batteries, you
must reprogram the remote control.
Some newer VCRa are capable of workti_g
on either of two remote codes. These VCRs
have a switch labeled "VCR f/VCR2."
If your VCR has this kind of switch and does
not respond to any of the codes for your
VCR, set the switch to the other position
(VCRf or VCR2) and reprogram the remote
control.
To Next Page
Loading...
