Connections
Antenna
Connect the antenna cable/s to your TV.
External Devices
PLEASE ENSURE BOTH UNITS ARE SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source button on the remote control. Or press the centre of the control switch inwards consecutively until the Sources list is displayed.
HDMI connection
Power
After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the mains. Plug the power cable to the mains socket outlet.
Plug the power cable to the mains socket whilst in ‘off’ position, and then turn the mains socket on.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
Switching On The Tv
In order to turn the TV on from standby mode:
Press the Standby button, a numeric button or Programme +/- button on the remote control
Press the centre of the control switch inwards, located at the rear left hand side of the TV
Internet Connection
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired or wireless connection.
Wired