IntroductionConnecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
AppendixIndex
23
Adding channels to the TV’s memory
When you press Channel y or z, your TV will stop only on the
channels stored in the TV’s channel memory.
Follow the steps below and on the next page to program all active
channels into the TV’s memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 24).
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until the TV/CABLE is highlighted, and then press
ENTER to display the pull-down menu.
3. Press y or z to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight CABLE.
LANGUAGE
SET UP
CLOCK SET
TV
CABLE
ANT 1 / 2
TV / CABLE
CH PROGRAM
ADD / ERASE
SELECT::SETENTER
T I LT CORRECT I ON
4. Press ENTER.
5. Press z to select CH PROGRAM.
LANGUAGE
SET UP
CLOCK SET
00:00
ENGLISH
ANT 1 / 2 ANT1
TV / CABLE CABLE
ADD
CH PROGRAM
ADD / ERASE
MOVE::STARTENTER
T I LT CORRECT I ON
0
6. Press ENTER to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
“Programming Now—Please Wait” appears.
7. When channel programming is complete,the message
“Completed” appears.
8. Press Channel y or z to view the programmed channels.
123
456
7
89
ENT
100
0
POWER
RECALL
CHRTN
FAV
FAV
TV/VIDEO
+10
PIC
SIZE
EXIT
INFO
STOP
POP DIRECT CH MUTE SLEEP
TV/VCR PAUSE
FFREW
SKIP/ SEARCH
SPLIT
SWAP POP CH
LIGHT
REC
CH SCAN
FREEZE SOURCE
PLAY
TV
CBL/SAT
VCR
DVD
VOLCH
FAVORITE
ENTER
DVDMENU
MENU
T
O
P
M
E
N
U
G
U
I
D
E
C
L
E
A
R
E
N
T
E
R
MENU
yzx •
Channel yz
ENTER
To Next Page
Loading...
