– 16 –
GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
Horizontal
WIDE mode
Horizontal phase: [HPOS]
Horizontal amplitude: [WID]
Side DPC: [PARA]
Trapezoidal distortion: [TRAP]
Corner distortion: [CNR]
Center distortion: [CPAR]
Parallelogram distortion: [CSAW]
DPCS letter distortion: [HSC]
Super-live mode
Horizontal amplitude: [WID]
Side DPC: [PARA]
Trapezoidal distortion: [TRAP]
Horizontal phase [HPOS]
DPCS letter distortion: [HSC]
Corner distortion: [CNR]
CINEMA mode
Horizontal amplitude: [WID]
Side DPC: [PARA]
Trapezoidal distortion: [TRAP]
Horizontal phase: [HPOS]
DPCS letter distortion: [HSC]
Corner distortion: [CNR]
Use PAL WG Philips Pattern and adjust the horizontal amplitude so that the mask will be adjusted to the frame of the left
and right flag sections at WIDE mode. Use [WID].
Use PAL WG Philips Pattern and adjust by [PARA] and [TRAP] so that the side pin distortion and trapezoidal distortion will
be optimized at WIDE mode.
As for the horizontal screen position, use horizontal phase [HPOS] and adjust so that the position will come to the center.
• Note: If the distortion adjustment by [PARA] and [TRAP] was insufficient, use
the DATA of [CNR], [CPAR], [CSAW], and [HSC] for adjustment.
When the distortion occurs as shown in Fig. (a), decrease [CPAR].
On the contrary, increase [CPAR] for the distortion of Fig. (b).
When the distortion occurs as shown in Fig. (c), decrease [CSAW].
On the contrary, increase [CSAW] for the distortion of Fig. (d).
When the distortion occurs as shown in Fig. (e), decrease [HSC].
On the contrary, increase [HSC] for the distortion of Fig. (f).
Use PAL Philips Pattern and adjust the frame of the left and right flag sections to the mask at Super-live mode.
Adjust so that the side pin distortion and trapezoidal distortion will be optimized.
If further adjustment is required, use horizontal phase [HPOS], corner distortion [CNR], and DPCS letter distortion [HSC]
for adjustment.
Use PAL Philips Pattern and adjust the horizontal amplitude so that the mask will be adjusted to the frame of left and right
flag sections at CINEMA mode.
Adjust so that the side pin distortion and trapezoidal distortion will be optimized.
If further adjustment is required, use horizontal phase [HPOS], corner distortion [CNR], and DPCS letter distortion [HSC]
for adjustment.
Adjustment items
Adjustment methods
3. Data Adjustment
To Next Page
Loading...
