Toshiba 40BV700G - Troubleshooting Common Issues; Picture, Sound, and Video Playback Problems; PC Mode, Analogue Text, and Remote Control Issues; PIN and General Query Resolution

English - 38 -
Q
Why th VCR/DVD pi bl
ac
kd
Q
Questions and Answers
Below are the answers to some of the most common queries.For more information, go to www.toshiba.co.uk
Q
Why is there no sound or picture?
Q
Why don't the controls of the television work?
A
Check the television is not in standby mode.
Check the mains plug and all mains connections.
A
Check that CHILD LOCK is not selected.
Q
Why is there a picture but no sound?
Q
Why is the sound only coming from one speaker
when stereo sound is selected?
A
Check the volume has not been turned down or
that sound mute has not been selected.
A
Check that the balance in the SOUND menu hasn't
been set to one side.
Q
What can cause a poor picture?
Q
Why are there problems with analogue text
service?
A
Interference or a weak signal. Try a different
television station.
A
Good performance of the analogue text depends
on a good strong broadcast signal. This normally
requires a roof or loft aerial. If the text is
unreadable or garbled, check the aerial. Go to the
main index page of the analogue text service and
look for the User Guide .
Q
Why doesn't the video/DVD being played show
on screen?
Q
What is DVB-T?
A
Make sure the VCR or DVD player is connected to
the television as illustrated in the beginning
chapters, then select the correct input by pressing
SOURCE.
A
Digital Video Broadcast via an aerial/antenna.
Q
Why is the VCR/DVD picture in black and
i
s e c
t
ure
i
n an
white?
Q
How are radio channels selected?
A
Check the correct input has been chosen.
A
You can select them via the Channel List.
Q
Why is there a good video picture but no sound?
Q
What can be done if the PIN number has been
f
or
g
otten?
A
Check the SCART lead connection.
A
You can reset TV and perform first time
installation. Ensure that no-one else can
use this by removing the Owner’s Manual.
Q
Why doesn't the remote control work?
Q
Why are there horizontal stripes and/or blurred
images on the screen when in PC mode?
A
Check the batteries aren't dead or inserted
incorrectly.
A
The Phase may need adjustment. Select PC
Settings and highlight Phase and adjust until the
picture clears.
installation. Ensure that no-one else can
use this by removing the Owner’s Manual.
TOSHIBA_MB61_[GB]_3910UK_IDTV_(IB_INTERNET).indd 38TOSHIBA_MB61_[GB]_3910UK_IDTV_(IB_INTERNET).indd 38 26.10.2010 11:00:1326.10.2010 11:00:13