Toshiba 40E200U - Removing the Pedestal Stand

6
Removing the Pedestal Stand
1) Carefully lay the front of the unit face down on a
flat, cushioned surface such as a quilt or blanket.
Leave the stand protruding over the edge of the
surface.
Note: Extreme care should always be used
when removing the pedestal stand to avoid
damage to the LCD panel.
2) Remove the four screws shown in the right
diagram. This will allow removal of the pedestal
stand.
3) Once you have removed all four screws, holding
the pedestal stand in place, remove the pedestal
stand from the TV.
CAUTION: Always place the TV on the floor or a sturdy,
level, stable surface that can support the weight of
the unit. To secure the TV, use a sturdy strap from
the hook(s) on the rear of the TV to a wall stud, pillar,
or other immovable structure. Make sure the strap is
tight, secure, and parallel to the floor.
37” TV
Four screws
VESA Moun ing Pattern
Hook
Sturdy strap
(as short as possible)
Four screws
32” TV
VESA Moun ing Pattern
Hook
Sturdy strap
(as short as possible)
40” TV
Four screws
VESA Mounting Pattern
Hook
Sturdy strap
(as short as possible)