FIRMWARE UPDATING PROCEDURE
Analog - Digital SW update via USB
1. Please copy the files to USB device (root).
Mb9x_en.bin
mboot.bin
usb_auto_update.txt
2. Turn power to OFF by mechanical switch or removing AC plug and plug the USB to TV
3.
Press the OK button consecutively for ~5s and at the same time power on the TV set by AC plug.
After ~5s you can release the OK button and shortly after front LED will start blinking and indicate that
the update has started.
4. When the blinks of led is stopped, TV opens autamatically.
5. Power OFF / ON TV set, then TV will be ready
When TV is ON
1. Software can be upgraded on Software Upgrade Mode.
2. To access Software Upgrade Mode, you will need to enter “1505 with your remote controller,
3. When main menu is on. On this mode, a simple yes/no screen appears which asks to upgrade the
software.
4.
In the USB Mass storage devices, there should be the binary whose name likes ‘upgrade_mb9x.bin’.
5. You will see a simple progress menu which shows the status of the upgrade,
6. This will be completed by restarting of the system
2
To Next Page
Loading...
