3-62 420 Series
Interrupt level
This option sets the interrupt level for the sound system. The available
settings are:
IRQ5, IRQ7, IRQ9, IRQ10 (Default)
NOTE: Sound Blaster compatible software uses IRQ7 as the default.
If you use this software, change the software setting to IRQ10. If you
cannot change the software setting, change the hardware setting to
IRQ7.
DMA (direct memory access) channel
Use this option to set the DMA channel. The available settings are:
Channel 0, Channel 1 (Default), Channel 3
6. Others
Whether or not you need to configure the computer with these options depends
primarily on the kind of software or peripherals you use.
(a) Power-up Modes
This option lets you choose between AutoResume and boot mode. You can
also set this option using hotkeys. AutoResume is effective with either the
internal LCD or with an external monitor.
Boot Turns on boot mode. (Default)
Resume Turns on the AutoResume feature.
(b) CPU Cache
Use this feature to enable or disable the CPU cache.
Enabled Enables the CPU cache. (Default)
Disabled Disables the CPU cache.
When enable is selected, a subwindow similar to the one below is displayed
to let you select the cache write policy. The options for this setting are
Write-back (default) and Write-through.
Option
Write Policy = Write Back
To Next Page
Loading...
