420 Series 4-15
4.6 CD-ROM Drive
Removing the CD-ROM Drive
To remove the CD-ROM drive, follow the steps below and refer to Figures 4-13 to 4-15.
1. Turn off the power to the computer. Disconnect the AC power cord and all
external cables connected to the computer.
2. Remove the battery pack, optional PC card, and optional memory module as
described in Sections 4.2, 4.3, and 4.4.
3. Turn the computer upside down.
4. Press the release lever lock to unlock the release lever.
5. Pull up on the lever to unsnap it. Then, raise it gently until the CD-ROM drive
module pops out slightly. Don’t force the lever back too far.
Figure 4-13 Removing the CD-ROM drive module
6. Grasp the drive and pull it out.
To Next Page
Loading...
