4-40 420 Series
6. Continue releasing the mask along the sides (four latches on each side) and at the
top (four latches).
Figure 4-42 Removing the display mask
Installing the Display Mask
To install the display mask, follow the steps below and refer to Figures 4-42 and 4-41.
1. Set the display mask in place and secure the latches beginning with four
latches at the top of the display mask.
2. Continue along the sides (four latches) and bottom of the display (four
latches.
NOTE: Support the back of the display with your hand when you secure
the screws.
3. Secure the display mask with four M2.5x6 screws.
4. Attach the two rubber seals and two rubber cushions to cover the screws.
5. Install the optional PC card, optional memory card, and battery pack as de-
scribed in Sections 4.4, 4.3, and 4.2.
To Next Page
Loading...
