English - 1 -
1
Building and tting stand
2
Inserting the batteries into the remote
Remove the back cover to reveal the battery compartment. Insert two 1.5V
size AAA batteries. Make sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on. A message will be displayed on the
screen when the batteries are low and must be replaced.
In order to prevent injury and maintain
stability of this TV, secure it to a wall(or to
another immovable structure), as shown
in the illustration, using a sturdy strap
and the P clips. Make sure the strap is
To Next Page
Loading...
