6
7)
VESA Mounting Pattern
TV Size Hole Pattern(HxV) Screw Size
65” 400x400 mm M8
(unit in mm)
Removing the Pedestal Stand
1)
Carefully lay the front of the unit face down on a
flat, cushioned surface such as a quilt or blanket.
Leave the stand protruding over the edge of the
surface.
Note: Extreme care should always be used
when removing the pedestal stand to avoid
damage to the LCD panel.
2) Remove the six screws shown in the below
diagram. This will allow removal of the pedestal
stand.
3) Once you have removed all six screws holding the
pedestal stand in place, remove the pedestal stand
from the TV.
65” TV
CAUTION: Always place the TV on the floor or a sturdy,
level, stable surface that can support the weight of
the unit. To secure the TV, use a sturdy strap from
the hook(s) on the rear of the TV to a wall stud, pillar,
or other immovable structure. Make sure the strap is
tight, secure, and parallel to the floor.
Six screws
Hook
Sturdy strap
(as short as possible)
VESA Mounting Pattern
To Next Page
Loading...
