Using
the
Basic
Features
* Channel Scan: Search
for
the
channels
automatically. Select
the
desired TV source before
starting
the
channel scan.
If
you
want
to
cancel
the
scanning, press
BACK
button,
and press OK
to
continue
the
scanning.
* Single
RF
Scan: (Only
for
DTV
source) Search for
RF
Channels Manually.
Press
◄/►
button
to
select
the
RF
Channel
No.
If
you
want
to
cancel
the
scanning,
press
BACK
button,
and press OK
button
to
continue
the
scanning.
* Analog
Manual
Scan: (Only for
ATV
source) Search
for analog channels Manually.
Press
OK
button
to
ente
the
interface
of
inputting
the
start frequency. Select
"Scan
Up"to
search towards frequency higher than the
start frequency. Select"Scan
Down"to
search towards
frequency lower than the start frequency.
If
you
want
to
cancel
the
scanning, press
BACK
button,
and press
OK
button
to
continue
the
scanning.
* Channel Skip/Move/Edit: Skip/move/edit
the
channel you want.
* Analog Channel Fine Tune: (Only for
ATV
source)
If
the
reception
is
clear, you
don't
have
to
fine
tune
the
channel,
as
this
is
done automatically
during
searching and storing operation.
If
the
signal
is
weak
or
distorted, fine
tune
the
channel manually.
Press
◄/►
button
to
adjust
the
frequency until
the
image
is
clear.
* Clear Channel List: Clear
the
channel list.
16
Setup
LiveTVSettings
Setup
Sticker
Demo
Fast
Boot
Screen
Mode
Auto
Standby
0•
HBBTV
Support
""
Time
Setup
Subtitle
Teletext
Network
HDMI
2.0
Setting
Postal
Code
DisClaimer
Record
Setting
Signal
Information
Standby
Auto
Tuning
""
Reset
Default
Note:
The
picture
is
only for
reference.
•
Sticker
Demo
Turn on
to
demonstrate main features
of
the
TV
for a shop display.
•
Fast
Boot
Turn on
or
turn
off
the
function
of
fast boot.
1)
If
you
turn
off"Fast Boot" function in "Setup"
menu, and press POWER(!)
to
power
off
the
TV.
Both
the
TV and
the
system will close
to
fully save
energy. In such
case,
it
will take long
time
to
power
on
the
TV again.
2)
If
you
turn
on "Fast
Boot"function
in "Setup"
menu, and press POWER(!)
button
to
power
off
the
TV,
the TV will close,
but
the
system still runs
continuously.
In
such
case,
it
will take short
time
to
power on
the
TV again.
•
Screen
Mode
Select
the
desired screen mode. Choices are Auto,
Normal, Letterbox, Panorama, Zoom and
Dot
by
Dot.
Note:
1)
This
function
is
only available after
you
have
searched
for
channels.
2)
Choices
differ
by
different input
signals.
To Next Page
Loading...
