Tuning the television
Before switching on the television put your decoder and media recorder to Standby if they are
connected.
To set up the television use the buttons on the remote control as detailed on page 5.
Initial Setup
Connect the television to the main power
and press the
button. The Initial Setup
screen will appear at rst use.
Press to start the initial setup.
Initial Setup
Welcome to the initial Setup wizard.
Please press [OK] to start the wizard.
Welcome
Using ▲ or ▼ to select your language, and
then press ►.
Initial Setup
Please select your language:
Back Select Next Exit
EXIT
English
Language
Français
Español
Italiano
Ελληνικά
Български
Deutsch
Press ▲ or ▼ to select your country and
press ► for the next step.
Initial Setup
Please select your country:
Back Select Next
EXIT
United Kingdom
Country
Luxembourg
Italy
Norway
Sweden
Bulgaria
Netherlands
Exit
4
To start a channel scan press ►.
Initial Setup
First, please connect antenna.
Start channel scan now ?
0%
If you skip this step, the channel
scan can be performed from the TV Menu.
Back Select Next
EXIT
Scan
Channel Scan
Skip Scan
Exit
A search for all available stations will begin.
The slide bar will move along the line as the
search progresses.
NOTE: If you skip this step, the channel scan can
be performed from the TV Menu.
If the television cannot be connected to a media
recorder/decoder with a SCART lead, or if a
station on another system is required, use
Manual Scan to allocate a programme position.
NOTE: The time will be set automatically using
the broadcaster data but can be advanced or
decreased by up to 12 hours using Time Zone in
Timer.
PLEASE NOTE
The Factory Default menu can also be accessed at
any time in Parental from the FUNCTION menu.
To Next Page
Loading...
Need help?
General
