Using the Remote with VCR or Cable TV Converter
• To control a TOSHIBA VCR, first set the TV-CABLE-VCR switch to "VCR" position. The buttons shown below will then
control the _/CR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program your Remote to control it.
Details are on page 11.
• To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your converter.
See page 11.
Set the [b/-CABLE-VCR switch to "CABLE" position whenever you control the cable TV converter.
Aim at the VCR or cable TV converter
TV-CABLE-VCR switch
"CABLE" : To control cable
TV converter
"VCR" : To control VCR
Channel number buttons
Press the numbers
desired for direct access.
S-i:OP button
Press to stop the tape.
REC button
Press to start recording.
ffV/VC R button
Press to._he,,TV mode to vi#w
one program while recording
anot h e_-"_ro_a m.
J
/
i
i
CCAPT
_o_ _ _-
POWER button
Press the button to turn t'he
VCR (or corwerter) on.
Press again to turn off.
---- CHANNEL k/'_r buttons
Press • bL_'tton to select next
higher channel.
Press Y' button lo select next
lower channel.
CH RTN button
See page 18.
_ PLAY button
Press to begin tape playback.
REC TV/VCR REW FF
TOSHIBA
J
_-- FF button
Press to ral3idly advance the tape. In
playback mode, press to viewthe picture
moving rapicily in forward direction.
REW buttc n
Press to rewind the tape.
In playbac_ mode, press to
view picture mc,ving rapidly in
reverse.
P
The shaded buttons can be used to
control the cable TV converter,
!
10
To Next Page
Loading...
