Toshiba CF32F50 - Page 11

Programming the Remote Control
_This Remote Control is preprogrammed to operate TOSHIBA VCR's.
• To use VCR's ott_er than Toshiba models (or Cable converter), perform the following procedures before operating.
- oou
@@
CH
VOL
:AVV MENU FAVA
RESET_ @I__XIT
STOP SOURCe- PLAY PIP
CK) CZD
REC TV/VCTI PEW FF
®0@®
STILL L(X]ATE SWAP
TOSHIBA
--RECALL
Number
For future reference, write the code
you used.
VCR CODE:
CABLE CODE:
2
3
4
Refer to the "VCR code table" (or "Cable TV converter code table")
on pages 10 and 11 to find the code number that corresponds to tile
brand name of ¥our VCR (or your converter).
If more than one number is listed, try each one separately until you
find the one that works.
Set the TV-CABLE-VCR switch to "VCR" (or "('ABLE").
Hold down RECALL while pressing the Number buttons for the three
digit code number for your brand of VCR (or converter). -
Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
-If the right number was entered, the VCR (or the converter) should
turn on.
-If the VCR (or the converter) does not respond to the Remote
Control, repeat steps 1 to 4 with another cocle number.
Notes:
• You have to reprogram the Remote Control_vhen you change its
4
batteries.
• Some newer VCR's are capable af working on either of two remote
codes. These VCR's have a switch labeled "VCR1NCR2".
If your VCR has this kind of switch, and does not resl3ond to all the
code numbers for your VCR brand name, set the switch to another
position ("VCRI" or "VCR2") and reprogram the Remote Control.
I
O
O
E
t-
C
E
E
t_
>
€-,
o
>
I--
I
>
r-
E
€,-
11