Programming Channel Memory
The; channel memory is the list of TV channel numbers your TV will stop on when you press the CHANNEL • or Wr button.
First, use the "FV/CABLE and OH PROGRAM functions to preset all active channels in your area.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired
chamnels.
[
/ CHANNEL •/A I
I --/+ POWER
ADV
MENU
MENU
ADV _I'--
cCAPT RECALL pOW _
®®®
@®@
o
FAV • FAV
-- POWER
--CHANNEL
T/•
ADV •
* This TV receives the following TV
.,;ignals:
1. TV: TV broadcasts signals.
(VJ-IFchannels 2 through 13 and
UHF channels14 through 69!
2.STD CABLE: Standa'td cable TV
signals.
-:3. HRC CABLE: Harmonic Related Carrier
cable TV si'gn-als.
4. IRC CABLE: Incremental Related
Carrier cable TV signals.
If you are not sure what CABLE system
they are using, consult your local cable
company.
1 Press POWER to turn on the TV.
2 Press MENU repeatedly until the Setup
menu is displayed on the screen.
3 Press ADV repeatedly until "TV/CABLE"
is displayed in magenta.
4
2
3
4
5
WiC#BLE: ITVISfD HRC [RC
fO SELEC[ ITEM PUSH ADV
"tO CCNTROL PUSH - +
Press- or + until the mode that corre-
sponds to your TV signal system is
displayed in magenta.
Each time you press the button, the TV*,
STD CABLE*, HRC CABLE* or IRC CA-
BI_E* mode will be selected in order.
- [TV]ST{) HRC IRC
fro SELECT ITEM PUSH _DV
CONTROL PUSH - +
Press MENU repeatedly until the Setup
menu is displayed on the screen.
Press ADV repeatedly until "CH PRO-
GRAM" is displayed in magenta.
CH PROGRAM
TO S[LEC'r ITEM PUSH ADV
TO COHTAOL PUSH - +
Press - or + to start channel program-
ming.
The TV will automatically cycle through
all the TV or CABLE channels depending
on the mode selected, and store active
channels in the channel memory.
When channel programming is; complete,
you will see the message at the right.
CH PROGRAM
TV
4!,
CH PROGRAMMING
COMP L ETED
TV
2 4
Press CHANNEL • or • to make sure the channel programming has
been done properly.
E
t-
¢3
E
E
Q.
t-
O
o
°_
t,--
15