Watching TV Programs
• First set the TV-CABLE-VCR switch on the Remote Control to "TV" position.
TV/VlDEO
TV/VIDEO
2
Channel
Number
EDS ADVA
ADVV
STOP SOURCE PLAY PIP
REC TVNCR REW FF
®O®®
STILL LOCATE SWAP
TOSHIBA
2
Note:
The VOLUME Y/• buttons on the TV
function as the -/+ buttons while any of
the, menu displays (Picture, Audio, Setup
- or Option) are on the screen.
2
3
Press POWER to turn on the "IV.
To turn off the TV, press POWER again.
Select a channel in one of the following two ways.
• To scan the memorized channels in numerical sequence
Press CHANNEL • to select the next higher channel.
Press CHANNEL • to select the next lower channel.
Press the button again to select the next memorized channels.
To select a channel directly
Press the Channel Number buttons (0-9 and 100).
To select channel 4, press "4" (or press "0", "4"}.
To select channel 38, press "'3", "8".
To select channel 125, press "100", "2", "5" in sequence.
If you cannot select certain channels, either ]_/(off the air) or
CABLE channels
Check if the TV/CABLE function is properly set. See page 13.
4
Press VOLUME •/Y to adjust the volume.
To increase the volume, press •.
To decrease the volume, press •.
VOLUME
-i --J+
T3 CONTROL PUSH ',0L
Watching Video Input
The TV/VIDEO button is used to view the signals coming from other
devices like VCR's or Laser disk players connected to this TV.
Details are on page 34.
Auto-Power-Off
If a wtcant channel is tuned or TV broadcast for a cay is finished, the TV
will automatically turn off after about 15 minutes.
This feature does not operate in the VIDEO mode.
Last Mode Memory .-
If the power is cut off while you are viewing the TV and theheoweris
resupplied, the TV is turned on automatically by the Last Mode Memory
feature. If the power is going to be off or when you leave home for a
long time, remove the power plug from the wall outlet to prevent the; TV
from turning on in your absence.
i :
_1_¸ _
0
<
0
E
m
•_ 0
Em
E.=_
17
To Next Page
Loading...
